|
|
| My lock keeps making a clicking noise, how do I stop it? |
| Put pin washer on top of plunger pin
PN#: PINWA1/2, PINWA1/4 |
|
|
|
| My lock is coroding, why? |
| The lock is water-resistant not water proof, if using lock in salt water, rinse in fresh water and dry with blow dryer. |
|
|
|
| My reinforcment busing on my lock is worn out, how can I replace it? |
| Due to the machining of the lock, the reinforcement cannot be replaced by itself, you will need to replace the entire lock or lower housing. |
|
|
|
| How do I change a lock to top loaded? |
| You can remove, replace, or service Prosthetic Design's locks without damanging the cosmetic cover.
To convert:
Step 1: Remove the (4) X-PS screws on the underside of the lock, and carefully separate the upper and lower housings.
Step 2: Remove (4) M6NUTs
Step 3: Install (4) M6X20TL bolts (included with lock)
Step 4: Reassemble lock and reinstall the (4) X-PS screws. |
|
|
|
| My plunger pin is wearing out rather quickly, how do I stop this? |
| This is from improper plunger pin alignment; the way to resolve this is to use a longer plunger pin along with a PYR, STEALTH360 or PYR-TL, or the RZ1 (this may require a new socket). |
|
|
|
| My push button keeps binding up, what should I do? |
| Loosen the (4) M6 bolts first, if this works then the socket attachment surface is not flat; if loosening the bolts does not work, disassemble the lock, clean and reassemble lock. |
|
|
|
| My push button keeps getting hit and my leg is disconnecting, how do I stop this? |
| Use our shorter push button that won't protrude as much OR use our pull release lock.
PN#: X-PSHB-SH or X-PUL-PLUS |
|
|
|
| How do I stop my Pyramid from rotating? |
| Tighten the four setscrews of your pylon or pyramid receiver. |
|
|
|
| How do I stop my Pyramid from sliding? |
| Tighten the four setscrews on the interfacing component. |
|
|
|
| Can I modify the CosmEasy? |
| Yes! The CosmEasy is made out of a urethane foam that can easily be cut to size or ground down to accomodate your desired shape. Also, stockings can be glued to the CosmEasy. |
|
|
|